could some one post where to find mugen cars and parts online?

i curently drive a nitrotc3 which is total joak and wanted to know where i can buy a real race car thanx!:D :tire: :D

You can buy through:

www.speedtechrc.com
www.speedline-rc.com
www.nitrohouse.com

or

Buy mine here's the link: (With everything provided will cost you much more) - you'll end up wanting the hop-ups and options :) and extra parts.

http://www.rctech.net/forum/showthre...threadid=20635

how much do you want for yours and would you still trade for a nitro tc3?

Actually still don't want to trade any more UNLESS you have enough new spares and hop-ups to match what I have. Furthermore if we do trade I'd rather just trade without engine. If you don't have a car that is of same value then you can purchase for $650.00 plus actual shipping cost. $550 without engine.

Here are the specs, spares, and hop-ups:

I have invested well over $1100.00 with hop-ups and spare parts.

Asking $650.00 plus actual shipping amount (Continental USA Only) Will accept PayPal for payment.

I will also include a Ofna Starter Box already setup for the MTX3.

- factory box and manual included.

Only has been used ½ gallon, includes break-in.

60wt shock oil Front and back
10,000wt rear diff oil

This car was setup with Integy setup guages and MIP tweak station. All settings are setup to factory specs.

The bottom is scraped, the pipe is dinged and need to replace the 2 speed gears soon (I have already purchased <listed below>), other than that you won’t be disappointed. All spare parts are still in packaging.

All these spare parts should get you through many races.

Here are the following spare parts and hop-ups: (Please note parts are included for the optional front diff gear :) )

I will trade ONLY for an equally hopped up NTC3 with equal spare parts. I will not accept the RTR version.

MTX-3 w/MT12 engine

Sato Seiki Aluminum Hop-ups (installed):

- SS-M-304 Alu. Anti-roll bar mount (Front)
- SS-M-301 Alu. Wheel Hex (4pc)
- SS-M-302 Alu. Mid Bearing Blockpad
- SS-M-305 Alu. Upper Brake Bracketpad
- SS-M-306 Alu. Engine Brace
- SS-M-311 Alu. Lower Brake Bracket
- SS-M-303 Center Support Mount

MMC 750mah battery pack (Special battery for MTX3)

Spare Parts and Mugen Upgrades (all parts listed below are new and still in packaging)

- T0242 MTX-3 Side Belt
- T0241 MTX-3 Front Belt (Quantity 2)
- T0221 MTX-3 Drive Pulley Set
- T021st MTX-3 1st Gear Spur Gears 47T
- T022nd MTX-3 2nd Gear Spur Gears 43T
- T0135 MTX-3 Front Upper Arm (left and right)
- T0136 MTX-3 Front Lower Arm (left and right)
- T0138 MTX-3 Front Upright (left and right)
- H0359 MTX-3 Teflon Brake Pad (OPTIONAL UPGRADE)
- T0305 MTX-3 Center Steering post
- T0402 MTX-3 Post and bumper parts
- C0502 MTX-3 Silver Pivot balls
- T0230 MTX-3 Front Dog Bones

More Spare Parts and Parts for OPTIONAL Front Diff (All parts are new and still in packaging)

- T0139 Rear Upright MTX3
- T0137 Rear Lower Arm
- T0710 2nd Gear 19T
- T0708 1st Gear 16T
- T0202 Diff Cup Joint
- T0210 O-ring set
- C0228 Diff Gear
- T0207 Gasket for Diff
- T0802 Roller Pin Set
- T0138 Front Hub set
- T0248 Mugen Seiki Titanium Middle Shaft (OPTIONAL UPGRADE)

Spare Screws
Fastener-Express.com screws

thanks man i have a car equally hooked up i just dont have the same amount of spares. was just asking because im only 16 and dont have 600$ to burn on a car.;) :tire:

Which hop-ups do you have?

hey puma I have a ntc3 fully hopped up and will trade I would not mind having a second mugen. I have hard core chassi stock chassi k factory tank k factory servo mounts k factory uper chassi and side brace gpm allumnim stering rack tit drive shaft rd logic all trans cases blade sway bar and all mountstit pilloballs k factory center bulkhead one way single chamber and dual chamber pipe centex clutch lots of spare parts arms nukles gears stock clutch and much more

Hey guys, please take all B/S/T stuff to PM or E-mail. Thanks. :)

I willing to trade as long as we can keep our own engines and I can keep my starter box and I would like to find out what color tran cases do you have? Would you have spares like arms and gears? If not could you purchase some spare arms front and rear and extra gears both for the clutch andthe 2 speed? That way I would have the same amount of spares I had for my MTX3.

i have the the blue drive shaft, graphite radio tray front spool rb x12 rear exaust engine associated tuned pipe front blade sway bar rear sway bar blue aluminum hexes, rd logics chasis,rd logics aluminum side braces, rd logics shock towers, and blue screw set.and a few more things with a 2.0 stratus.:D

Sorry...I will from here on out.

Sorry,
Puma

jiggamacdaddy and ilaybrk please email me at [email protected]

Thanks,
Puma

anyone know what would be the best engine to get for a mugen i am leaning towards a serio but am concidering a rb or a novarossi:D

wait for the latest released Novarossi engine i.e. NS12 3 or 5 ports. they are very powerful engines.

where is there a site i can see the engine and who will distribute them?