bobbyblaze

iTrader: (1)

I'm looking to get this car and i notice the shocks not threaded is there an upgrage?

Chickentrader

iTrader: (13)

All genuine G4RS Shockies have threaded ride height adjustments.

Kindest regards,
Lars.

bobbyblaze

iTrader: (1)

thanks for the info

impalabob64

iTrader: (2)

First staterace had a good weekend ,only problem battery dumped thats was the only issue, but overall the car was at its best this weekend at Homestead track in Miami will post setup later.

blis

Impala, are you using the TM AAA packs or do u use an alternative?

impalabob64

iTrader: (2)

TM AAA i need to find an alternative though, im going to see if i can use the normal 5 cell pack but have to make it so it mounts under the gas tank an flat on the chassie will keep you posted.

blis

When making up my own cells, I slip short lengths of heat shrink over each end of the batteries to prevent grounds touching each other. It spaces each cell apart slightly and is more durable than the harder shrink that TM uses.

impalabob64

iTrader: (2)

Thank for that tip

GMartinez

iTrader: (91)

Bobby your car was on point & driving as well good luck at the next race

Doug M

impalabob64

iTrader: (2)

Front Susp

Track Width-198mm
Anti-Roll Bar-0 (K14213)
Diff- 300,000 X-Ray
Front Toe - 1
Camber L2-R2
Front Ride Height-5mm
Front Droop- 1mm
Caster 3mm
Tire -ContactTires 37L-37R
Shocks Kyosho (1/8th short shock bodies)
Oil -600 wt kyosho
Piston -2hole 1.1mm
Spring -Serpent Red (old version)
Ackermann-B

Rear Susp
Track Width-199mm
Anti Rollbar-0(k14231)
Diff 80,000-X-Ray
toe 2.5mm
Camber 5.0L-4.5R
RideHeight-6mm
Droop 4mm
Tire-ContactTires-40L-40R
Shocks Kyosho (1/8th Long shock bodies)
Oil-600wt kyosho
Piston-2hole 1.1mm
Spring X-Ray DarkBlues

Optional parts i ran on the car.
Ceramic bearings
k14220
k14219
k14243
k14234
k14239
k14240
k14257
K14200
k14212
k14201
k14228
Titanium Hinge pins
Lightweight Middle Shaft
Lightweight Diff outdrives Front&Rear
Lightweight Bevel gear shafts for the diffs
Lightweight pulleys only used the 19t pulleys only.

impalabob64

iTrader: (2)

Engine-MM RbM3/w INS box
Pipe-Nova 2530
Header-Nova short
Gearing-17/62 23/58
Fuel-J-Tech 16%
For qualifying i ran 32shore Contact tires front,an 37s on the rear
Body-Stratus 3.1

rcpaintinpete

iTrader: (16)

MR WATSON I NEED A PIC OF THE LAST BODIE ON THE CAR

flynia

With a lot of help from my mates at the LHS here in Canberra I have finally got around to getting the new Motor into my G4RS 09.

She is now good to go and "Run In" (Thanks Team at Stryke RC here in Canberra)

Hope you all like and enjoy and I'll keep you posted on how it goes!

premeet01245

u can do it... think about it...