Need quick answer about a OS .12TR engine
#1
Need quick answer about a OS .12TR engine
I am replacing the Piston & Sleeve along with the connecting rod and pin.
My question is this:
Do I use both of the retaining clip when putting in the pin? It looks like there isn't room on one of the sides. The other side has some indentions and a groove where the clip goes.
Thanks.
My question is this:
Do I use both of the retaining clip when putting in the pin? It looks like there isn't room on one of the sides. The other side has some indentions and a groove where the clip goes.
Thanks.
#2
may be there is a stoper made on the piston body(smaller diameter) in this case only one clip, other wise two got be there