Serpent 720
#3601
Paolo you have a PM
Whats good Apolaro.
Demeterius
Whats good Apolaro.
Demeterius
#3602
Tech Elite
#3603
Tech Adept
iTrader: (11)
Centax Clutch Question
I have a Novarossi Plus 12-3SCT. My question is about the two clutch bell bearings. I have the first bearing on, then the bearing spacer, and finally the last bearing. But, the last bearing doesn't fit all the way down on the shaft, is that going to be a problem? I measured the space between the top of the shaft and the top of the bearing and it is 1.40 mm. I have shims behind the bottom bearing, if I don't, the clutch bell will rub. Any help would be appreciated.
Last edited by Serpent720; 07-24-2008 at 09:18 AM.
#3604
The T-nut that goes thru the thrust bearing will take care of the rest of that space....If you look at the stack built on the t nut, with the washers you will see the t nus sticking thru about that amount... Build according to directions, set your end play first, with no inner bearing, the TOTAL endplay, so the clutch bell rubs on the shoe, then set the slop end play with the inner bearing, good to go!
#3605
Tech Adept
iTrader: (11)
The T-nut that goes thru the thrust bearing will take care of the rest of that space....If you look at the stack built on the t nut, with the washers you will see the t nus sticking thru about that amount... Build according to directions, set your end play first, with no inner bearing, the TOTAL endplay, so the clutch bell rubs on the shoe, then set the slop end play with the inner bearing, good to go!
#3606
you can use any clutch shim's...i'm using TM left over shim's from that old car..
#3608
#3609
Tech Elite
Looks nice guys!!
#3611
Tech Elite
Thanks,
Why are you not coming?
Why are you not coming?
#3612
#3614