truggy understeer
#1
Tech Rookie
Thread Starter
truggy understeer
have good turning radius on the car but the front end pushes in turns like the front end is light. any advice? like lowering ride height or shock setups?
#2
List general details of the type of track. Be sure to list the tires used, and your setup information. Springs, shock oil, diff oil and etc. Try posting in this D8T forum.
http://www.rctech.net/forum/nitro-of...ruggy-543.html
#3
Tech Rookie
Thread Starter
yeah its a d8t. ill look into the d8t thread like u said to see what pops up
#4
I would say try a little bit of toe out on the front end keep in mind there your steering will be quicker and a little harder to drive.
Make sure the steering saver isnt to loose thats the first thing i would check.
Make sure the steering saver isnt to loose thats the first thing i would check.
#5
Tech Elite
iTrader: (36)
Check what they said on the above posts first. Then if it is still pushing, make sure you dont have too much front brake. If it still pushes, check your rear droop, and front shocks. More rear droop will help transfer weight to the front under braking. Your front shocks are either too stiff and not allowing the weight to transfer or too soft allowing them to bottom out. Then lastly, lengthen your wheel base.
#6
Tech Rookie
Thread Starter
ight man i will check that out thanks. just looking for little changes that i can do without changing the whole setup.
#7
Tech Rookie
Thread Starter
[QUOTE=Jerm13;10929953]Check what they said on the above posts first. Then if it is still pushing, make sure you dont have too much front brake. If it still pushes, check your rear droop, and front shocks. More rear droop will help transfer weight to the front under braking. Your front shocks are either too stiff and not allowing the weight to transfer or too soft allowing them to bottom out. Then lastly, lengthen your wheel base.]
ok will do thanks.
ok will do thanks.