Tony's Screws or RcScrewz Stainless
Looking to rebuild my Hara and need a screw kit, it is between these 2. Any input would be great
thanks |
Tony's by far, better quality and won't strip easily like rcscrewz.....
|
stainless are pretty weak compared to Tony's 12.9 grade alloy
|
If money isn't a issue, I'd go lunsford screws. My tki2 has luns tit screws throughout and have been awesome. They will last a very very looonnng time. Also, no matter what set of screws you get, I highly suggest you investing in MIP/Thorp hex drivers. Best I've had so far. Just my 2cents
|
Eeeh
I like steel screws. I never bought Tony's, but I go to A Main and order all the srews from their protech brand. You get like 10 screws fro 2 dollars or whatever. I just load up with all the sizes I use the most and bam. It ends up being cheaper than 45 dollars for a screw kit and you have 20 of each not only a few.
|
TONYS over any other on the market. You get more for the money with Tonys Screws..
I'll never stray again. |
Originally Posted by ScottyM
(Post 10739464)
TONYS over any other on the market. You get more for the money with Tonys Screws..
I'll never stray again. |
If Trick-Parts makes a kit I would go with them. I have them in my scte and caster buggy and haven't had a stripped out screw yet.
|
Stainless screws tend to strip out much easier. I'd avoid the RCScrewz set -- they look cool, but WILL strip out. I had a bad experience years ago when I first got started back in RC.
10.9 or 12.9 steel is the way to go. Tony's offers a nice pre-packaged set. Titanium is nice, but mainly on the top plate where there is lower stress. I wouldn't use them on the high stress areas, especially engine screws and lower chassis screws. Have seen them bend/break on many occasions. |
I agree with larlev, go with trick-parts.com, they have great quality stuff
|
Tony's NO question's asked, He's got Kits for 98% of the cars out there and his hardware is the BEST in the Bizz. :nod:
|
tony, Nothing else...
|
Stainless for Rock Crawlers...Tony's for EVERYTHING else :)
Later, |
Well that settles it, Tony's it is.
Thanks for the input |
|
All times are GMT -7. It is currently 08:58 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.