R/C Tech Forums
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

R/C Tech Forums (https://www.rctech.net/forum/)
-   Nitro Off-Road (https://www.rctech.net/forum/nitro-off-road-130/)
-   -   what pipe for torque (https://www.rctech.net/forum/nitro-off-road/404566-what-pipe-torque.html)

RC-ZOMBIE 06-03-2010 05:17 AM
Originally Posted by R/C Lidz (Post 7492240)
his gearing is fine; 16/44 is the stock kit ratio for an RC8. The diffs are geared differently than most buggies so the 16 (or optional 170 tooth clutchbells are normal. You could go up to 16/46 if wanted.
Yeah, his gearing is fine.

Johnieblaze 06-03-2010 08:51 PM
Originally Posted by RC-ZOMBIE (Post 7492484)
Yeah, his gearing is fine.

I never stated that anything was wrong with his gearing, however, gearing down from a 16 to a 13 on the bell and up a few teeth on the spur or some combination of both will definitely give him results, if not solve the problem completely. I had the same issue.

losi_racer 06-03-2010 09:35 PM
Originally Posted by JAMMINKRAZY (Post 7489797)
Is this the ninja JX 21 or MR 21? If it is the JX, something is wrong. You should have PLENTY of bottom. Even in a truggy the JX has an overpowering bottom end. I would look more to tuning and clutch than the pipe. 2035 should give you the bottom you need.;)
i agree with u jammin, my truggy gets thrown around with my jx .21/2042 like a rag doll and i using a light clutch set up. Ive never ran a 2035 on my ninja, the 2042 is awesome tho


All times are GMT -7. It is currently 11:47 AM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.