yuppi1

iTrader: (13)

Hi i took my car for a run today and it seemed sluggish at the top end so i adjusted the high end screw did a high speed pass went great turned around and then it became sluggish again and when i got it back to me the screw is vibrating itself out. is thier an easy way to fix this or what do i have to do?

Thanks in advance
Tony

David Wall

iTrader: (8)

Sounds like you need new o rings

wingracer

iTrader: (24)

What motor?

I had this problem with an RB onroad motor once. For some reason it only had 1 o-ring on the needle. Local shop had a needle in stock with 2 o-rings. It was much tighter and cured the problem.

token

+1 new o rings

losi_racer

iTrader: (25)

x2


although i have heard two different local people. one intermediate and one expert ran a serio engine, new might i add. and in the first race the needle screwed it self in on two DIFFERENT engines

yuppi1

iTrader: (13)

cheers guys just wasnt sure where i should start looking.

yuppi1

iTrader: (13)

the motor is a power racing .27