losi_racer

iTrader: (25)

ok i got my vspec put all back together but i was just wondering...

during breakin should i use ONE copper gasket or TWO? ive only read one but idk

jamiekerr14

I personally used 1.. what method you doing by the way.. I recommend this .. on I did..

http://www.johnnycoolguy.com/JCGR/ma..._break-in.html

losi_racer

iTrader: (25)

its a mix between the heat cycle and idle thru tanks.

Sholler

iTrader: (1)

Same method i used on my Extech. The key is to keep it in the 200 degree range while running it around. I used a piece of aluminum foil and a ziptie to try and hold a little extra heat in the head. Nothing will kill a motor faster then dirt, and running it too cold. So far so good...............