vspec break in help
ok i got my vspec put all back together but i was just wondering...
during breakin should i use ONE copper gasket or TWO? ive only read one but idk |
I personally used 1.. what method you doing by the way.. I recommend this .. on I did..
http://www.johnnycoolguy.com/JCGR/ma..._break-in.html :nod: |
Originally Posted by jamiekerr14
(Post 5544429)
I personally used 1.. what method you doing by the way.. I recommend this .. on I did..
http://www.johnnycoolguy.com/JCGR/ma..._break-in.html :nod: |
Same method i used on my Extech. The key is to keep it in the 200 degree range while running it around. I used a piece of aluminum foil and a ziptie to try and hold a little extra heat in the head. Nothing will kill a motor faster then dirt, and running it too cold. So far so good...............
|
All times are GMT -7. It is currently 05:35 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.