What does your wrenching table look like? post a pic.
#406
#411
Tech Addict
iTrader: (13)
Browsing through these pics, I see a few guys hanging there nitro buggies from walls nose down. Does this do any damage to front engine bearings or anything else? I would of thought that it would eventually cause the front bearing to leak?
What is the best way to store your nitro?
What is the best way to store your nitro?
#412
Tech Regular
I'm one of those who hang it nose down. I do it because I want the after run oil to go down into BOTH bearings inside to protect them during storage (long or short). The after run oil will also go into the front bearing and lubricate of course. On one truck I have Roto start system and the nose down prevent oil to leak out of the engine into the starting device.
#413
Imo Store Flat, No Tires and Shocks Dismounted.
#414
Tech Lord
iTrader: (148)
Charger station is operational in the pit trailer. There is a 60 amp power supply wired with deans wet noodle to 3 outlets with 4mm input
It's getting close to being complete I will give you a before and after once its finished. But for now its DNC time......
Added a bench with storage in the front too
It's getting close to being complete I will give you a before and after once its finished. But for now its DNC time......
Added a bench with storage in the front too
#415
Niice.
#416
Tech Master
iTrader: (114)
Looks awesome Frank. Good luck to you at DNC...Keep that fuel locked up!
Charger station is operational in the pit trailer. There is a 60 amp power supply wired with deans wet noodle to 3 outlets with 4mm input
It's getting close to being complete I will give you a before and after once its finished. But for now its DNC time......
Added a bench with storage in the front too
It's getting close to being complete I will give you a before and after once its finished. But for now its DNC time......
Added a bench with storage in the front too
#419
Private security eh, Who woulda Thunk.
#420
Tech Rookie