rc8t
#107
congrats shane on the crc state finish! your awsome to watch down there!
#109
Tech Apprentice
Hi all
Could anyone please give me the lengths of the RC8T wheels hex 89329 and 89330? Also, will need the pin diameter?
I am looking to mod another vehicle with these hubs but I need to keep to as close as possible to the original length so my zero offset wheels don't contact the front arms at full turn. I was recommended these hubs because of the captured pin setup.
Forgot to add that the other hubs I tried which positioned the pin within the wheel when fitted were too narrow and didn't work with my AKA wheels.
Could anyone please give me the lengths of the RC8T wheels hex 89329 and 89330? Also, will need the pin diameter?
I am looking to mod another vehicle with these hubs but I need to keep to as close as possible to the original length so my zero offset wheels don't contact the front arms at full turn. I was recommended these hubs because of the captured pin setup.
Forgot to add that the other hubs I tried which positioned the pin within the wheel when fitted were too narrow and didn't work with my AKA wheels.
Last edited by N-1; 07-12-2014 at 03:42 PM. Reason: More info
#110
Tech Adept
iTrader: (30)
I took my rc8t ce out to revelation raceway over the weekend. It still scoots good. It's not the newest ride on the block but it's fun to drive and It was turning excellent. Anyone else out there enjoying their rc8t or has everyone else moved on with their life? This thread has been dead since 2009 for be most part.
#111
Tech Fanatic
iTrader: (16)
I've still got mine. It's even the older version with the carbon fibre shock towers
Been on the shelf for a few months now, but seriously considering dusting it off again.
By the way there is another rc8t thread that has had much more recent activity than this one.
http://www.rctech.net/forum/nitro-of...-tips-297.html
Been on the shelf for a few months now, but seriously considering dusting it off again.
By the way there is another rc8t thread that has had much more recent activity than this one.
http://www.rctech.net/forum/nitro-of...-tips-297.html