![]() |
Originally Posted by josht21
(Post 12835452)
what do I put in my ring gear
|
ok and what is a good set of tires of mud and a set of tires of snow
|
on my summit the rc does not move at all ar very little would bad gears in the transmission make that happen
|
I would check and make sure your slipper isn't too loose.
|
Originally Posted by frontedge
(Post 12839281)
I would check and make sure your slipper isn't too loose.
Nope the slipper is fine it turns good |
The summit does nit move when on ground but when I pick the truck up the tires do move but sounds like crap the center drive shafts turn when it sits on the ground but truck does not move can some one help me
|
Is it possibly stuck between hi and low? If not does it do this in both high and low?
|
Originally Posted by frontedge
(Post 12853399)
Is it possibly stuck between hi and low? If not does it do this in both high and low?
|
Can you make a video of what it's doing?
|
Originally Posted by TheKennyKiller
(Post 12855894)
Can you make a video of what it's doing?
|
It is not doing it right now bit it does it on and off
|
If it does it again whip the camera out, preferably with the body off so we can see what the gear selector servo is doing.
|
Ok I am guess it is the diff tho
|
I found the problem with my rc it was the diff bit thanks for all the help
What would be a good set of tires of my summit |
what is your opinion on big joe tires for my summit or are trenchers x better
|
| All times are GMT -7. It is currently 05:02 AM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.