gguertin145

iTrader: (9)

has there been any talk of big bores on the truck or will this just be for the buggy and truck shocks to come later?

SkarTisu

iTrader: (8)

There will be big bores for the B4*, B44* and T4* platforms. I don't know if all the shock lengths will arrive at the same time, but that's the hope.

BSchorr

iTrader: (101)

BRAAAAPP!!




B4.1 WE Setup

Front:
AE 30wt
#2 GHEA pistons
2 limiters
TLR 12mmBB orange 2.9lb springs
2-Out shock position
1-A camber link w/ 1 washer
30* casterblock
Axle middle
2 washer bump
-1 camber
0 toe
24mm ride height

Rear:
AE 27.5wt
#2 GHEA pistons
2 limiters
TLR 12mmBB yellow 2.0lb springs
1-In shock position
1-B camber link w/ 0 washers on ground rear brace
0 degree rear hubs w/ AVID "C" towers
Hubs middle
2 anti squat
-1 camber
23.5mm ride height
3.5 toe in
AE ballast weight
1/4 oz in right-rear chassis triangle, not on left side.
1/2 oz next to reciever
Battery has big pad in the rear, 1/2pad in the front

TLR 22 bottom spring retainers
Traxxas big bore top spring retainers using stock AE spring adjuster
AVID steering rack
3M clear bra chassis protector

Proline 2012 B4.1 Bulldog
Proline M3 4-ribs
Proline M3 Holeshot 2.0's

soup99

iTrader: (12)

This might be a dumb question, but, what is or who is "GHEA"

wrightcs77

iTrader: (551)

not a dumb question...

Aftermarket pistons run by a nine volt battery you can get them at pepboys

Rocky8333

iTrader: (30)

The Ghea pistons have a taper to them, and therefore change the pack of the shock in one direction, much like the tapered 8th scale pistons. I found them to be much more forgiving on landings than the standard #2 pistons. I think I talked Ben into getting them .

I found them here.

SkarTisu

iTrader: (8)

Here it is, folks! The RC12R5.2! Available this month

http://www.teamassociated.com/news/l...ory_Team_Kit!/

ammdrew

iTrader: (25)

shop has them on BO.... hopefully end of month

snowmobile2004

iTrader: (2)

Gearing help for spec sedan at mmr.

SkarTisu

iTrader: (8)

With a Reedy Sonic last year, I ran 31-33 pinions and 93 or 96 spurs. That was with a fan. I suggest starting at 31/96 and check temps every couple of minutes while you're working out the final gearing

haywood

iTrader: (49)

3.8-4.0. Watch temps! Fan a must!

bds81175

iTrader: (20)

Can't believe I've never seen this freakin' thread before. All I own is AE!!

snowmobile2004

iTrader: (2)

Is that 64 pitch. Because 48 pitch won't fit if you gear it that big?

haywood

iTrader: (49)

Yes. We run 64 indoors.

Rocky8333

iTrader: (30)

Super-dialed.