Hey whats up. Was running my buggy today (d8) for another break in session and I lost steering and tapped a small pole.

The reason I lost steering was because the arm for the steering servo stripped out. maybe I did not have my epa adjusted correctly. But during this little crash I had the screws to pull out of the bulk head on the front. It was the screws going into the rear. The hinge pins seem to be ok as well as the hinge pin plates. To prevent this from happening in a race can I get a alum servo horn. I am using a ace steering servo the 1313.

Also would you take the chance on running the same bulkhead or would you get another to replace it.

how do u like the go tech 5 port on your hot bodies d8 i have a hot bodies d8 and a os vg .21 and was woundering if i switched to the go tech 5 port would it be any faster and if the engine last

I am trying to find us mail order fuel cheap. My chassis is out getting 4 oz taken off of it and my bodie is out getting done also. And Powerhouse just shipped my mill back to me TKO ceramics new rod pin clips o-rings the works.

.