RC SCALE TANKS corner
#1
future plans:
- extend detailed accs.
- add more lights
- add 2-3 channels for scale purposes
- replace the stock TX to a more channel TX
- extend detailed accs.
- add more lights
- add 2-3 channels for scale purposes
- replace the stock TX to a more channel TX
Last edited by sLith; 04-14-2011 at 10:48 PM.
#4
@Sir dongskie - nice tank sir.. any modification you made there?
@etivac13 - nabili ko po yung tank ko sa divisoria mall 168 dun po yung mga henglong brands much cheaper than tamiya but same detailed din ung akin po 1/16 henglong snow leopard with sounds, lights and firing pellet....soooper enjoy sia talaga
@etivac13 - nabili ko po yung tank ko sa divisoria mall 168 dun po yung mga henglong brands much cheaper than tamiya but same detailed din ung akin po 1/16 henglong snow leopard with sounds, lights and firing pellet....soooper enjoy sia talaga

#5
Here are a few mods I did:
METAL SPROCKETS

RX18 UNIT

GRAUPNER SPEED 700 MOTOR

HIGHER RATIO GEARING FOR ULTRA CRAWL SPEED

MODIFIED THE INTERIOR FOR A MORE ERGONOMIC LAY OUT

BIGGER SPEAKER

METAL SUSPENSION ARMS

HERE IS MY PANZER III AUSF/1
METAL SPROCKETS

RX18 UNIT

GRAUPNER SPEED 700 MOTOR

HIGHER RATIO GEARING FOR ULTRA CRAWL SPEED

MODIFIED THE INTERIOR FOR A MORE ERGONOMIC LAY OUT

BIGGER SPEAKER

METAL SUSPENSION ARMS

HERE IS MY PANZER III AUSF/1
#6
@dongskie - sir ilang volts ung pinalit nyo pong large speaker? how about the replacement of reciver? any ideas? im planning to use my futaba atack 4wd with custom 2channel add-ons and a 8ch rx
if im not mistaken the stock ratio of a 1/16 tanks by henglong is 1:147 so what is your final ratio now after the those mods sir?
if im not mistaken the stock ratio of a 1/16 tanks by henglong is 1:147 so what is your final ratio now after the those mods sir?
#7
@dongskie - sir ilang volts ung pinalit nyo pong large speaker? how about the replacement of reciver? any ideas? im planning to use my futaba atack 4wd with custom 2channel add-ons and a 8ch rx
if im not mistaken the stock ratio of a 1/16 tanks by henglong is 1:147 so what is your final ratio now after the those mods sir?
if im not mistaken the stock ratio of a 1/16 tanks by henglong is 1:147 so what is your final ratio now after the those mods sir?
Im not exactly sure sa ratio, but mine is definitely higher na.. ang laki ng difference sa stock gearing, mas may crawl na talaga..

Btw here was my M-26 Pershing, removed the side skirts.
Last edited by Dongskie; 02-23-2011 at 02:38 AM.
#11







[/IMG]
[/IMG]