SmacTrac Raceway, St.Louis, MO
#107
Tech Adept
That was a really fun night of racing, had a blast. Thank you all for the kind words, it means a lot and I'm glad everyone is having fun! How about that last corner pass in the dash for cash?!?!
#108
#111
Tech Regular
iTrader: (35)
Had a lot of fun Friday night also it was good to see some of the guys that don't race outdoors much. I was a little hesitant on coming because I am in outdoor mode and like having indoor and outdoor seasons. I might have to rethink that and show up on Friday nights a little more often. However last year I missed about 2 or 3 Saturday races so I do fully support the Saturday race program and always look forward to the fall when it starts.
#112
Had a lot of fun Friday night also it was good to see some of the guys that don't race outdoors much. I was a little hesitant on coming because I am in outdoor mode and like having indoor and outdoor seasons. I might have to rethink that and show up on Friday nights a little more often. However last year I missed about 2 or 3 Saturday races so I do fully support the Saturday race program and always look forward to the fall when it starts.
#115
Baumgartner, if I order the jconcepts turnbuckles for my 22 will the kit come with the right size turnbuckles since I have the bellcranks?
#116
Tech Adept
Chris - Whoops! lol
Last edited by Baumgartner; 05-16-2015 at 03:26 PM. Reason: .
#117
Tech Apprentice
They will work. I have them on my car with the bellcranks. They're 3.5mm, so they will work with angled and straight HD ball cups. The part number you need is JCO2362
#118
So you didn't run into a problem with the turnbuckles being to long for steering? Did you do any cutting?
#119
Tech Apprentice
I didn't have to cut anything, but I did have to thread them in pretty far. I ran them in and out a few times to try and cut the threads in the cups more and free them up.
#120
R/C Tech Elite Member
iTrader: (207)
T5m hex issue!!!!
I attempted to install clamping axles and 8.5mm hexes on front of truck...,.went to tighten clamp screw and it just snapped off leaving me the head, screw broke off inside....anyone else experience this? Btw, im down for this Friday...woot!
I attempted to install clamping axles and 8.5mm hexes on front of truck...,.went to tighten clamp screw and it just snapped off leaving me the head, screw broke off inside....anyone else experience this? Btw, im down for this Friday...woot!