rayhuang

iTrader: (5)

rc-zombies-I sent you a PM at RCTECH. Please shoot me an e-mail when you can!! Very important. [email protected]

Thanks!!!
Ray

rc-zombies

iTrader: (9)

all purpose lubrication. available from your home hardware or automotive store.

also works as traction compound for foam tires.

itchynads

Are you talking about the fluorine coated shock shafts?

Not that it makes much of a difference to many...I'm not a good enough racer to notice it

rc-zombies

iTrader: (9)

got you PM..sent you an email this morning...

sengming

what do you soke the bearings in?
i want to soke my new ta04-r bearings.
thanks

TRF414M

I saw a guy yesterday opening the kit. It has all the mounts (7 in total) and all the accessories and spares available. I was sort of amazed that Tamiya is basically giving this car away with a very competitive price.

rayhuang

iTrader: (5)

rc-zombies-call me at work tomorrow!! 1-888-551-1044 toll free.

I really want to get two of these, 5 if the price is right!!! I already have a post in the swap and sells!!!

Ray

itchynads

I use WD40, its cheap and it works. After soaking, spray the bearings with motor spray and apply a drop of bearing oil to it.

rayhuang

iTrader: (5)

Well-even though I have a TC3 with a new narrowed chassis and machined nitrolon arms to test, a XXXS with new rear suspension and belt to try-I bought a TB EVO3 today!!! Somebody just shoot me please!!!!

I am psyched. When anybody has a good carpet/ foam set-up to start with-please post it here !!! If not-I'll just take the set-up off of my TC3 and put it on the EVO.

PizzaDude

Rayhuang.

I know this is off-topic so please reply direct (PM) or on the tc-3 thread.
Could you tell or show something about the "nitrolon" arms?!

Thanks,
Pizza

rc-zombies

iTrader: (9)

Ray
I tried to call you...gone for the day? They said you will not be in tommorrow too?

No word yet on my contact....

you can email me direct at [email protected]

Evoracer

iTrader: (24)

rayhuang,
you're a sick, sick man. You need help !! In the interest of saving you from your EVO3 buying self...you should cast out the evil and send me that car!!! It's the healthy thing to do!!!

itchynads

Ok so far so good...finished building the universals and have attached them. All that's left are those shocks

The car does not look as wide as my 414m2 for some reason, and I needed to place red spacers on the hex hubs .

Tamiya have been pretty generous with their spares, lots of spare spur gears and bevel gears. All the parts that generally see lots of wear and tear are well stocked in the kit. Only spares they did not include are the steel hinge pins which I tend to bend alot of

The slop in the kit is way less than my 414m2. The steering links are fairly slop free. Even the lower arms don't need shimming.

PizzaDude

Itchy,

That sounds really nice.
Any downfalls yet?

Regards,
Pizza

alan1467

Just finished building my EvoIII. nice kit and Tamiya have included a lot of spares and set up option. For foams and carpet I'm going to start with my 414M2 setting and work from there

Frt
Ass purple springs
60 Wt
Hard Blue tyres
1.8MM ARB

rear
Ass copper springs
40 Wt
Green tyres
NO ARB

I'll let you all know on Sunday what worked!!!!!!