XRAY X12'16
#3
#4
#6
#7
#8
Tech Rookie
Extra front body post
#12
Reminds me of when Pietsch first went to Mugen. You could tell he built the promo MRX-5 because it had a mix of Mugen and Shepherd screws in it.
#13
#15
Tech Regular
iTrader: (4)
So they say the easy to shim rear pod but those I fail to see how it is easier than doing one screw, sliding the axle out, pop the plastic insert out, pop new ones in, slide the axle in and tighten the hub. Versus removing the 4 screws, try to keep the damn tiny shims on the screws. If they would have put in long setscrews and nuts, it would have been easier to slide the shims on them and then put the bulkheads on.