kinga

iTrader: (15)

The car bogs down less through the corner with less lateral grip, and will carry more corner speed, tyres wont "squeel" as much.
Hagbergs app is pretty sweet but lacks a tuning guide to help with specific handling scenarios like the old RC Setup workbench app from martin crisp.
Tip for Alex: Put a "handling matrix" section in your app so if you are chasing a particular handling scenario such as "loose on power" you can offer a step by step on how to fix it like Martins app did, but more up to date.

ronallen

iTrader: (9)

What's a good gearing for 17.5 blinky. Short track. Thanks

millbank

4.5 ish

locked

iTrader: (1)

Depends on the motor, amount of endbell timing as well as the size and flow of the track, but 4.5 would be on the under geared end of the spectrum.

I'm usually somewhere around a 3.8 FDR with the timing not quite fully cranked on most smaller tracks

ronallen

iTrader: (9)

What spur should I start with. Also which pitch. Running on carpet

branover

iTrader: (29)

64 pitch. Start with a 96 spur and pinions ranging from 42-48. I run a 46 on a fairly large track

Bryan D

Has anybody tried/tested the Spec R motor mount and single layshaft mount for the Xray T4'15 ??

Thanks

B00t13g

iTrader: (9)

I have one I'll sell you. $30 shipped.

spencehotbodies

Not good?

Lonestar

iTrader: (14)

take a guess

theproffesor

iTrader: (66)

Ron you going to start running at BRR? Should be a decent group this Sunday.

B00t13g

iTrader: (9)

How do you feel about replacing stripped spurs?

Skiddins

How does it manage to do that, too much flex in it?

If you manage to keep the spur in one piece how does it feel?

EDWARD2003

iTrader: (8)

+1

Danny-b23

iTrader: (3)

Hey guys, just did a regional race here in Western Canada and did pretty well against some pretty good drivers.

See my write up and setups here.

http://www.teamxray.com/teamxray/new...b1b91265a7f732