Yokomo MR4TC-BD
#8851
#8852
Let's Move!
Alright gentlemen and loyal Yokomo racers, we have a new home on the R/C Tech forum:
New Yokomo TC, the BD-5
let's all move over to that thread for the new car
New Yokomo TC, the BD-5
let's all move over to that thread for the new car
#8855
Tech Elite
iTrader: (102)
Join Date: Dec 2004
Location: Far away from Covid19 but close to 20
Posts: 4,129
Trader Rating: 102 (100%+)
Support Yokomo
Yok diehards..
it's finally arrived....that Yok blue once again rises.
This is better than my upcoming wedding...shh...don't tell her that..
Steve....PM your way about LHS accounts.
it's finally arrived....that Yok blue once again rises.
This is better than my upcoming wedding...shh...don't tell her that..
Steve....PM your way about LHS accounts.
#8858
Tech Addict
iTrader: (35)
Both.......
http://www.rctech.net/forum/r-c-item...cvds-rare.html
Jason, have you ever used these in a BD?
http://www.rctech.net/forum/r-c-item...cvds-rare.html
Jason, have you ever used these in a BD?
#8860
Tech Elite
iTrader: (120)
Both.......
http://www.rctech.net/forum/r-c-item...cvds-rare.html
Jason, have you ever used these in a BD?
http://www.rctech.net/forum/r-c-item...cvds-rare.html
Jason, have you ever used these in a BD?
#8862
Tech Addict
iTrader: (35)
rayspeed
I just hung them each from the pin hole on the axle, the front rayspeed is shorter and the rear rayspeed is longer than the bd ones.. If you look at the ones in the BD the fronts are already towards the end of the outdrive, and the rears are way up in the outdrive. The rayspeeds would make them worse, it is not alot, but it was to much for my comfort when I originally tried to use them. I am pretty sure I tried shimming some and still wasn't happy.
#8864
Tech Addict
iTrader: (35)
If measured from the axle pin, they are a diffrent length. Everthing else I have for the BD no matter what shims, collars in the hubs I have to use, they are the same total overall length from the pin to the bone. They may work, but they are not the same and were to close to the edge of the front outdrive and to far up in the outdrive in the rear for my liking.
#8865
Tech Elite
iTrader: (2)
If measured from the axle pin, they are a diffrent length. Everthing else I have for the BD no matter what shims, collars in the hubs I have to use, they are the same total overall length from the pin to the bone. They may work, but they are not the same and were to close to the edge of the front outdrive and to far up in the outdrive in the rear for my liking.
Hey Orin, I heard you are still doing really well with the BD....
Have you figured out they fitment issues with the RaySpeed Unis?