Yokomo MR4TC-BD
#151
Tech Champion
iTrader: (31)
Re: And the pics are up......
Originally posted by Mabuchi540
http://www.yokomo.co.jp/yokomonew/ne...gatsu/BD-3.jpg
There ya go people
http://www.yokomo.co.jp/yokomonew/ne...gatsu/BD-3.jpg
There ya go people
-Dave
#153
#154
Tech Master
Yeah but....
Originally posted by KilRuf
For easier access..... http://www.yokomo.co.jp/yokomonew/ne...s/products.htm
For easier access..... http://www.yokomo.co.jp/yokomonew/ne...s/products.htm
#156
whoooooo i got the name right! MR4TC BD
any ideas about the batt slots?
any ideas about the batt slots?
#157
Tech Master
My guess.....
Originally posted by pheyhoe
whoooooo i got the name right! MR4TC BD
any ideas about the batt slots?
whoooooo i got the name right! MR4TC BD
any ideas about the batt slots?
#158
could be... i just wrecked a pack of fukus tonight because they were sticking out too low.
its looks ok, but it sure as hell looks like it will be flexy. theres no deffinition of the car. everything looks a bit mangled and wishy washy. i think this is because of the milled out sections...
its looks ok, but it sure as hell looks like it will be flexy. theres no deffinition of the car. everything looks a bit mangled and wishy washy. i think this is because of the milled out sections...
#160
Tech Master
Yes but.....
Originally posted by pheyhoe
could be... i just wrecked a pack of fukus tonight because they were sticking out too low.
its looks ok, but it sure as hell looks like it will be flexy. theres no deffinition of the car. everything looks a bit mangled and wishy washy. i think this is because of the milled out sections...
could be... i just wrecked a pack of fukus tonight because they were sticking out too low.
its looks ok, but it sure as hell looks like it will be flexy. theres no deffinition of the car. everything looks a bit mangled and wishy washy. i think this is because of the milled out sections...
#162
I'm guess the battery slots (if you look closely they are plastic cell holders) might be for different battery types? A plastic holder for GP3300.. for GP3700.. for Sanyo 3600... etc... This assures better battery fitment...
#163
haha, posted at the same time...
#164
those battery slots look like they have been changed with photoshop!
What material would it be be made?... doesn't look fimilair to me.
What material would it be be made?... doesn't look fimilair to me.
Last edited by Tekin; 02-27-2005 at 05:02 PM.
#165
As long as the spur gear is easier to get to than the old TC!!
That was no fun. Looks pretty good. HAve to wait and see what the drive ratio is!!! Lower than 2.5 i hope!!!any body keen for a guess?
That was no fun. Looks pretty good. HAve to wait and see what the drive ratio is!!! Lower than 2.5 i hope!!!any body keen for a guess?