Tony Vega

iTrader: (8)

You'll have some side to side play on your layshaft so you may want to shim it.

cooliomojo-CEBU

tony,

thanks for the advice....will follow it...

Yeti35

iTrader: (5)

Yo Pookyt, you in IIC?

POOKYT

I'm working on it!!!! No conformation email yet.

Brant

Still Bill

iTrader: (16)

Yeti and I confirm that you can come watch us...

POOKYT

OK Mr.Smaty-Pants!!!!!

I have signed up for 19 and mod rubber tire. This will be an experience!! Hopefully a good one!

Brant

scoyle

I put a new set of arms on the front of my car tonight with the BK additional hole built in (I was running the kit arms before). I have noticed that the bottom of the spring and the spring cup touch the hub carrier. Is this normal?

By the way I removed the 3.17mm from the ball end to allow for the suspension travel.

Thanks,
Stephen

rayhuang

iTrader: (5)

Stephen,

Newer caster blocks come premolded with a relief for the spring perch-if not-dremel it.

Tony Vega

iTrader: (8)

Space both the bottom and top out a bit to help clear the caster block. With the new hole you will probably drop down in spring rates too.

Still Bill

iTrader: (16)

So, my new on-line name should be Mr. Smaty-Pants.

And I thought I was smart.

Thanks for the idea...

Yeti35

iTrader: (5)

Pookyt, I would not even have said anything that cold!! But since he said it, you are welcome to watch us!!

Still Bill

iTrader: (16)

That's me! Old and cold!

Yeti35

iTrader: (5)

Oh, and you need to get a new name you TRAITOR!!!

Still Bill

iTrader: (16)

Thinking about that.

My original use of XXX-S Bill and JRX-S Bill over these three years has been to pay homage to Team Losi and the superior support received from Todd, Matt, Gil Jr. and a few other present/past team members.

These guys have been stellar; so, thinking about changing my name has been a difficult task to say the least! I will get there...Maybe by the time the IIC comes around it will be done.

????? Bill

POOKYT

LOL......You two guys are goofy!

Brant