BMI 1/12 conversion/car
#106
pic2
#107
pic3
#108
pic4
#110
that is very good looking car...
#114
It's tuff to see on the pics.... but the top plane of the car is slammed down. The top pod plate is so low that a mod. motor sticks above it. The standoffs on the t-plate pivots are .28" tall, the original concept was .46" tall. The out board standoffs are .56" tall, the 12L4 has .75" tall standoffs. The dampening tubes are lower, the shock is lower, the pod plates are also lower.... The motor has tons of room to drop right out of the bottom. The milled channels for the tape have 45 chamfers so the carpet wont catch, for that matter the whole chassis is chamfered, no sanding needed!! There are new personal transmonder mounts in the front and 2 hole positions for servo mounting (flat or angled). There are multiple antenna mount positions, and 2 rear body mount positions. The milled area in the pod plates for the ride hgt. adj. are perfect!! The rear axle is perfectly parallel to the ground and square to the t-plate.
-Wayne
-Wayne
#116
Wayne - Friggin AWSOME! Reading "no sanding needed" just made my day!
Last edited by fatdoggy; 09-17-2004 at 03:15 PM.
#118
Wayne, You and Jason are some bad dudes. Great ideas all around definately BMI quality stuff. I cant wait to see how it runs.
Speedie
Speedie