BMI 1/12 conversion/car
#331
Ray... I run my tires the same diameter front and rear... With the number 4 ride hgt. adj. I run 1.75 front and rear... So i've been going threw all my old tires!!! The tires I ran at the Holloween race were from last year at the nats!! Got my money worth!!! If I start them about 1.78 front and rear by the end of the day I'm at 3mm for the main
#336
Wow Wayne, Patience is a..... Well its something stupid Im sure I have none of either. Ya can at least give the guy a chance to wake up and eat some wheaties. I cant wait to get mine on the track and rip up the carpet. You at least have gotten to run the prototypes we all have to sit hear and listen and wait.
#338
Tech Master
iTrader: (14)
Wayne:
Hi,
do you have any setups for the BMI 1/12th scale car??? I am hoping to get one and Mini will be going from a switchblade (02) to the BMI. I am hoping for one before Cleveland so Mini can get used to it. will be running disks instead of tubes. Also looking for a old Tecnacraft/Paragom floating disk setup.
Thanks
Hi,
do you have any setups for the BMI 1/12th scale car??? I am hoping to get one and Mini will be going from a switchblade (02) to the BMI. I am hoping for one before Cleveland so Mini can get used to it. will be running disks instead of tubes. Also looking for a old Tecnacraft/Paragom floating disk setup.
Thanks
#339
Ray...
No it's not.. Sorry
TimXLB...
Setup:
Front: CRC purple tires, .020 springs, 1 deg. camber, 5 deg. up rights, full Niftech tire traction, servo flat of chassis, 1.78 tire dia.
Rear: CRC Gray tires, #4 ride hgt., 25 wt. shock oil, silver spring, dampening disks with 100 wt. shock oil, thick t-bar, Full niftech tire traction, 1.78 dia. tires.
You don't need the floating system, the new dampner post works great.
Wayne
No it's not.. Sorry
TimXLB...
Setup:
Front: CRC purple tires, .020 springs, 1 deg. camber, 5 deg. up rights, full Niftech tire traction, servo flat of chassis, 1.78 tire dia.
Rear: CRC Gray tires, #4 ride hgt., 25 wt. shock oil, silver spring, dampening disks with 100 wt. shock oil, thick t-bar, Full niftech tire traction, 1.78 dia. tires.
You don't need the floating system, the new dampner post works great.
Wayne
#342
Are they done yet....
Are they done yet....
Are they done yet....
:-)
It's like waiting for Christmas.
Are they done yet....
Are they done yet....
:-)
It's like waiting for Christmas.
#345
Are the body mounts in the same spot? I have a new body but dont want to cut it out till I know I wont have to make new holes with the new chassis?