Serpent S411
#1771
Tech Master
iTrader: (8)
Yes. You will need a tool like the Huddy pin remover. I also suggest you heat up the drive shaft before removing pin. The pin is shrink fitted to the Shaft meaning the shaft hole is couple thousands smaller than the pin diameter. if you remove the pin without heating (therefore expanding the shaft) you may damage the shaft. then when you put the new pin in it may just fall off.
make sure you protect your hands and dont burn them.
Or you can buy a new shaft...
make sure you protect your hands and dont burn them.
Or you can buy a new shaft...
#1778
#1779
Nice video on building the Serpent RCC Shocks.
Fast forward to the 6minute mark, the guy talks quite a bit.
http://www.youtube.com/watch?v=0VuhopTCtA4
Fast forward to the 6minute mark, the guy talks quite a bit.
http://www.youtube.com/watch?v=0VuhopTCtA4
#1781
#1782
Good times
I guess I can stop trying to get the rebound to match.
Anyone else get this in their kit?
Anyone else get this in their kit?
#1783
Tech Adept
#1784