Thanks. And sorry again, I got flamed on another post I had because I asked a question, and was trying to nip this one in the bud.

We could run MOD 12th. I'll probably run stock 12th this weekend. Sounds like fun. Mikey may run stock 12th too. Then you'll have a real indicator of how far WE'RE off.

I try to give out impartial and universally acceptable advice. I will however direct you to what I feel are the finest products available, and that's pretty easy when it comes to chassis..........

I can only imagine..

Cool info. Thanks.

Hi all,

Here are some pics of the thrust race assenbly I have with the spacer I made to work with it.

Here is the thrust race and spacer

In this one you can see the shoulder on the spacer sits in the hub. There is no bearing on the outside, just one on the inside. When I ran the regular bearing I never used on on the inside so I've just effectively moved it inside.

In this one you can see the thrust washer on the hub side sitting in the spacer which centers it and helps to hold it away from the thread.

this time with the pic attached

Sweet. Will the HPI thrust bearings fit? They're 4x9x4.

rev,

no idea, I'll get one and check it out.

Chris

Consider one sold if it does.

i recieved an l3 in a trade, and it only had a bearing in the outside of the hub, so it may be missing the inside bearing on purpuse?
why is this?

Rev,

I don't know if I'm going to do production versions, they are a lot of work for what they are and I'm not keen on working for a dollar an hour. So far this has been for my benefit and I don't think I want to tread on Brian Bodine's toes. We shall see what comes of it.

Chris.