1/12th Scale Wiring...(1S)
With everyone using boosters, Li-Fe and LiPo batteries, voltage regulators, sensor wires and such, there doesn't seem to be much room on 1/12th scale cars for everything.
Looking for ideas on how to lay out my electronics, and your help would be appreciated. Post pics of your clean wiring job and help inspire me to shorten wires and quit zip-tieing everything. Cars running 1s lipo/booster/rx packs/brushless are preferred, but all 1/12 scale configurations are welcome. Thanks! |
I think there is already a thread with a bunch of pics somewhere, iwill see if I can post the link on here for ya
|
|
you run ko stuff, should be easy to layout your electronics with the smal 408 rx.
I run the speedo on the left and the rx on the right. if you run the length of the rx allong the length of the chassis right up agains the antenna, there is room for your rx pack just to the right of that. with all ko stuff, you just need the rx pack no booster and no regulator. if you run the ko rx, i would put all the motor wires up against the antenna. i run a tekin and i have the motor wires on the 1s lipo side |
the isgroup do you have a pic of your configuraton?
|
|
Originally Posted by TommyBlazin
(Post 6637968)
the isgroup do you have a pic of your configuraton?
Originally Posted by Geezatec
(Post 6638059)
Not one photo has 12th scale with lipo's & liFe. Emailed TEKINS the other day, & they said it is nessesary to run a booster or separate pack for the RX, and useing the Hotwire and set it to 1cell lipo's.
|
|
man, now that OD has posted a pic, I am afraid to post mine. it will never live up to anythign OD does
|
Originally Posted by theisgroup
(Post 6638587)
man, now that OD has posted a pic, I am afraid to post mine. it will never live up to anythign OD does
Hey OD, what iron/tip are you using to shorten all the small servo wires and such? -M |
Like use Deans T plug or Inboard Tube ?
|
1 Attachment(s)
Here is a picture of mine. This is using a HobbyCity booster (in black next to the receiver).
|
1 Attachment(s)
Here's mine:
|
Originally Posted by InspGadgt
(Post 6638864)
Here's mine:
Originally Posted by GWH74
(Post 6638784)
Here is a picture of mine. This is using a HobbyCity booster (in black next to the receiver).
|
Originally Posted by StickyFingaz
(Post 6638703)
Agreed. :nod:
Hey OD, what iron/tip are you using to shorten all the small servo wires and such? -M |
All times are GMT -7. It is currently 10:33 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.