LOSI XXX-S, Tips and Tricks, Open Mod, etc
#691
Cool, I remember what the spur/pulley combo looked like but haven't seen the adapter, I have software that will generate the pulley for me, so a few key dimensions and I should be able to make them.
I've done a couple delrin pulleys for drift cars before.
I've done a couple delrin pulleys for drift cars before.
#693
That looks pretty simple, I will have a play making one in the next week or so.
Can you put some calipers on it for me? need hole I.D. each side, total width, teeth width, height of the little boss on the spur side, also number of teeth.
Can you put some calipers on it for me? need hole I.D. each side, total width, teeth width, height of the little boss on the spur side, also number of teeth.
#698
Easier if I had it in hand, but the critical measurements will work fine too, no need for you guys to send me stuff, I will ask around here in NZ and see if anyone has one I can look at, or even and old standard spur/pulley so I can check clearances.
Keen to get this done for you guys, I like doing the stranger low volume stuff, gets my mind going!
Keen to get this done for you guys, I like doing the stranger low volume stuff, gets my mind going!
#700
Still run my TC4 so I know what you are talking about! haha
#704
Will do.
Will definitely be delrin, I've got a foot of black delrin rod here waiting to be turned into stuff.
#705
Very cool about the spur adapter. Would love to get a couple when there're done!!!