JR007

Since the introduction of 200, the RS thread is going bonkers! I figured it would be worth while to have a thread just for RS set-ups. The other thread is great for questions and queries/problems (which Randy and Co and handling amazingly), this one is ONLY for set-up's and relative feedback.

So, copy and paste the following list and add your details, to let everyone know your current HOT set-up. If you're not a grinch that is
Or, tell me this idea is arse, and scan the last 30 pages of the other thread looking for a set-up

Track surface
Traction (h/m/l)
Size (s/m/l)
Class
Chassis
ESC
Motor
Motor timing
Gearing
Battery

Firmware
Drag brake
Brake
Limiter
Neutral
Volt cut off
Motor type
Throttle profile
Sensored/dual
Timing advance
Push control
Timing boost
Turbo boost
Turbo delay

Fuzzy

iTrader: (4)

I'll second this motion. I think this would be a helpful thread.

rcpoint

Very good initiative.....let me start.

Track surface: asphalt
Traction (h/m/l): high
Size (s/m/l) : very large
Class 13.5
Chassis Tamiya 416
ESC RS Pro
Motor Fantom 13.5
Motor timing 0
Gearing 69/35 (4.05 FDR)
Battery fantom 5000 40c LiPo

Firmware 200
Drag brake 0
Brake 100
Limiter
Neutral 8
Volt cut off 2s
Motor type BL/FW
Throttle profile 5
Sensored/dual Sensored
Timing advance max
Push control 0
Timing boost
Turbo boost max
Turbo delay 0.7

Note: Motor cooling is essential (LRP has good solution), fastest laptime on the track and top speed (84km/h 52mls/h)

razzor

Track surface = Asphalt/slurry
Traction (h/m/l) = m
Size (s/m/l) = l +- 260m +- 50m straight
Class = 13.5
Chassis = TOP Racing Scythe
ESC = RS Pro
Motor = SP 13.5
Motor timing = stock - 12deg
Gearing = 45mm roll out - 62mm tyres - 1.94 int/ratio
Battery = Chargery 5200mah 25c

Firmware = 199
Drag brake = 40
Brake = max
Limiter = max
Neutral = 10
Volt cut off = 3.2
Motor type = bl/fw
Throttle profile = 4
Sensored/dual = sensored
Timing advance
Push control = o
Timing boost = 16
Turbo boost = max
Turbo delay = .6

Motor runs around 55 deg/c on day +- 25 deg/c ambient temp
Excellent punch and mid with good top end.
Will run 200 this coming weekend.

liljohn1064

iTrader: (17)

First Test setup for 17.5 Redline:

Track surface: Carpet
Traction (h/m/l): H
Size (s/m/l): S/M
Class : 17.5 Rubber TC
Chassis : JRX-S Type R
ESC : RS
Motor : Redline 17.5
Motor timing : 0*
Gearing : 118/43 FDR of 5.0
Battery : Trackpower 4900 25C

Firmware : 200
Drag brake :55
Brake : 85
Limiter : NA
Neutral : 10
Volt cut off : 6 Volts
Motor type : Brushless/Forward
Throttle profile : 4
Sensored/dual : Sensored
Timing advance :
Push control : Off
Timing boost : 20
Turbo boost : Off until final gearing is achieved
Turbo delay : .5

Randy_Pike

iTrader: (6)

I'd like to reccomend our editable setup pdf sheet for this thread. It has a notes section and is easy to fill out, save and post:

http://www.teamtekin.com/graphics/se...p-sheet-v1.pdf

HarryN

iTrader: (2)

Good idea indeed!

And Randy, thanks again for that editable PDF setup sheet! TEKIN F-ing RULES!! Managers like you do companies well.

Track surface - Asphalt
Traction (h/m/l) - low (dusty at the moment)
Size (s/m/l) - LARGE (110' x 50')
Class - 10th scale Mini (203 - 208 wheelbase)
Chassis - ABC Hobby Genetic
ESC - Tekin RS Pro
Motor - Tekin Redline 17.5
Motor timing - Factory (12 degrees)
Gearing - 2.7:1
Battery - Thunder Power 4300 MAh 25C, 2S

Firmware - Version 200
Drag brake - 0
Brake - 100%
Limiter - 0
Neutral - 3
Volt cut off - 2S Lipo configuration, LED 3??
Motor type - Brushless
Throttle profile - LED 4, Agressive, Low End
Sensored/dual - Sensored
Timing advance - +12
Push control - 10
Timing boost - 5
Turbo boost - 10
Turbo delay - .7 (technical track setup)

I am still doing some adjustments and I may have to go back to the Linear configuration for my throttle profile. The Turbo is having some issues with the Agressive Low End (LED 4) setup.

Low_E

sorry for going off-topic, but what are the differrences between Version 199 and 200? Is there such a big difference that a new thread is needed?

(I have been away for some time)

Skitee

Ii think the guys just thought that all of these setups would clog the RS INFO/TECH thread up, so they did thi solely for the "TURBO" setups.

John Tag

iTrader: (42)

Track surface - Asphalt
Traction (h/m/l) Med/high
Size (s/m/l) Med-100x50
Class 17.5 Touring Rubber
Chassis - Losi Type-R
ESC Tekin RS
Motor - Express DUO
Motor timing -Low
Gearing 4.30
Battery 5000-40C

Firmware -200
Drag brake -65
Brake -100
Limiter -off
Neutral -10
Volt cut off -off
Motor type -bl-fw
Throttle profile -3
Sensored/dual -sensored
Push control -off
Timing boost -30
Turbo boost -10
Turbo delay -.05

markny

iTrader: (17)

where can i get this version. can someone send it to me?

lidebt2

iTrader: (21)

Email Randy at: [email protected]

cyanyde

This thread is solely for setup. All else please go to http://www.rctech.net/forum/electric...-sensored.html

RoyU

iTrader: (2)

Anybody got a setup for 12th scale 4cell with 13.5 on small track 60' x 60' or similiar

bee200sx

iTrader: (20)

Great Thread!

Has anyone got more 17.5 setups? I just want to compare different settings and FDR everyone is using. Any tekin team drivers who have been testing this new software for a while now?