Corally RDX Phi 09
#1
Corally RDX Phi 09
Hi Guys since I haven't come across a specific thread for the new chassis I decided to open one. I just received my new kit yesterday and was wondering if any body out there has any tips or tricks we should follow before starting to build it.
It would be great to have some Team Corally drivers contributing to this thread every now and then.
I'll post some pics and give an update once I'm going through the build process.
Bye
It would be great to have some Team Corally drivers contributing to this thread every now and then.
I'll post some pics and give an update once I'm going through the build process.
Bye
#2
Tech Initiate
Hey bud did you buy it online?
#3
No i picked it up from my local shop here in Malta dhiracing.com
#4
Tech Adept
I'll post a basic setup in a few days.
#5
#6
Tech Adept
Tip for building, don't use the standard steel balls for your differential, but you the ceramic ones. It makes your diff feel a lot better, and it holds better so you don't have to rebuild it as much as a diff with normal balls. Furthermore ceramic's don't wear out easily so you can race an entire season with just 1 set of diffballs.
#8
#9
I took some clearer photos of some of the new features and differences, I will post up some more soon.
Diff Bearing holders are now moulded and bulkheads are keyed to the holders
Diff is the 08 Style but now in a gunmetal anodising rather than machined look
Bulkhead now has screw that can be removed for more grip on low grip surfaces, bulkhead brace no longer screws to the chassis and is only a brace between the bulkheads
New moulded front diff bearing holders and raised top deck
Diff Bearing holders are now moulded and bulkheads are keyed to the holders
Diff is the 08 Style but now in a gunmetal anodising rather than machined look
Bulkhead now has screw that can be removed for more grip on low grip surfaces, bulkhead brace no longer screws to the chassis and is only a brace between the bulkheads
New moulded front diff bearing holders and raised top deck
#11
#13
Has anybody noticed that the rear carbonfibre bearing holder isnt flush on the bulkheads when tightening it up? it stays at an angle do I have to place washers underneath it?
#14
How do Lipos fit? Does it still have the chassis slots for Nimh?
How does it adjust belt tension?
How does it adjust belt tension?