The Speed Passion Thread
Super Moderator
iTrader: (239)
oh wow , i was just about to try that fleta software , i think ill pass on it now lol , but if you send it ill try to load the SP file on it and see.
Tech Fanatic
iTrader: (6)
This is all assuming that the ESC isnt bad. Which version of the Fleta had you planned to use? I used the 1.4 I think.
Thank you, sir! I don't forsee the need for a lot of timing, but I figure why not get the newest version if I can? I just wanted to make sure it was genuine and not a clone so thank you for confirming.
Super Moderator
iTrader: (239)
Agreed I tested a lot of motors on my dyno and anslyzer and 90% of the time the majority of the motors perform very well between 40-42degress and the right gearing I never have a motor come off the track over 125 degrees
Last edited by Marcos.J; 08-10-2017 at 06:49 AM.
Tech Regular
iTrader: (2)
Tech Apprentice
store? what do you mean?
Tech Regular
iTrader: (2)
Tech Initiate
Hi, I have a gt2.1 ex esc. Is there anywhere I can download a manual from? Also can/do I need a program card for it? Thanks
Super Moderator
iTrader: (239)
Tech Regular
iTrader: (7)
Super Moderator
iTrader: (239)
Super Moderator
iTrader: (239)
I think I'm ready for next weekend's race
Tech Regular
iTrader: (7)
Tech Elite
iTrader: (43)
Hey guys pulling out some old gear to run TC again. I still have aMMM3.0 17.5 with yellow board and super 7 purple rotor. Is this still an ideal setup for touring car?
Super Moderator
iTrader: (239)