475LikesInspire us. Show me your BEST, CLEANEST electronics installation pics.
04-23-2009, 10:03 AM
#391
Rev. 5 Lipo
my best attempt at a neat lipo setup using the deans connectors. the bottom half of the deans is ca'd to the lipo so you can pull the speedo side or charger lead on/off. seems to work pretty good. This is the new car with the recessed lipo pocket.
04-23-2009, 10:32 PM
#393
--pakk
04-24-2009, 05:16 AM
#395
How do you guys black out all the wires? Especially the ESC and Servo wires???
(Born and Raised in East London SA)
04-24-2009, 06:16 AM
#398
04-24-2009, 06:37 AM
#400
Tech Apprentice
04-27-2009, 06:35 AM
#402
yes exactly, 13ga to battery, 16ga to motor. Running tq wire, very flexible, you can check it out here: www.tqracing.com
It's always better to just run 16ga. for everything in 1/12th, but i was able to get away with running 13ga in this situation. I figure why not especially being that its such low voltage it def. cant hurt any.
04-27-2009, 12:54 PM
#404
Here is a pair of TA05's. Top one is mine, and the second one belongs to a good friend. I did the soldering for him and helped him with the placement.
Mine needs a new shorter sensor wire. But other than that it is pretty clean I think for the tub chassis TA05.
Mine needs a new shorter sensor wire. But other than that it is pretty clean I think for the tub chassis TA05.
04-27-2009, 01:07 PM
#405
Finally! Heres my TM E4 C1 (T/A)