davepull

rct

AdrianM

iTrader: (4)

Come one guys....take a hint.... Barry hasn't posted here since December 8th.

Let this thread die untill he restarts it.....

davepull

man i had to listen to barry bust on Dumas for like ten minutes about not replying to his thread. when i brought up his thread (this one) he said things where going to change so I am just busting on him.

oh yah ask mcmoney to see catbrains!!!!!!!!

futureal

I have faith he'll be back... someday.

Calvin Ng

let me yahoo him.....

BigDogRacing

iTrader: (12)

Hey Mike Blackstock- how are things? Did Vicky have to talk to the cops after that incident in Orlando? Man that was scary. Just goes to show you never know....

I guess we'll see ya at the Nats. Why don't you do your own chat thread since Barry is too busy chasin tail to hang with the rctech guys?

trackdesigner71

iTrader: (6)

Hey Barry, check this out:

http://www.fishermenstudios.com/uspc/

stefan

Guys,

Barry did the 'Birds, then he went home to pack for Brazil and that's where he is right now, so give the man a break, will ya?

tc3 racer sc

what happen to mike/ vicky in orlando

EAMotorsports

iTrader: (79)

I think she was in a resturant on Sunday when it was robbed...But she made it out ok.... I heard it was a bad situation for a while though.

ea

Mike Blackstock

iTrader: (1)

Yea Vicky, My son dominic , and her father tony and stepmom janice , Where all in a restuarant on international drive when a guy came in and robbed the place.. They got out while he was on the other side of the resturant , We went back there later to get some belongings that they left there while leaving fast.. Found out the guy pulled the trigger on one of the host's and the gun jammed.. Wow.. He had them all lined up in the resturant like the movies ... He got away before the cops got there :-(

But atleast everyone came out ok..

Hope they get this guy sometime...

Mike

Mike Blackstock

iTrader: (1)

Things are good now...

Barry is very busy racing all over the world.. If i had to race as much as he do's i am not sure i could do it.. I mean he is one dedicated guy to do this.. I am sure he will be back on when time allows.. But as of now we are heading in to one of the craziest summers in a long time as far as race's go.. So do not be suprised if you do not see him.. I know he has alot on his plate..


I answer some ??'s now and then on somethings i think i can help on ..

Mike

True R/C Racing

Thats a Scary situation especially while your in a Restaurant trying have a good time eating, Next thing you know you have to Evacuate fast. Good Thing No one Was hurt

lowline

Hey mike just curious when you talk about running frt block in rear and lowering hinge pins does that lower the pins or do you have to mill it and if so how much thanks steve

Mike Blackstock

iTrader: (1)

The f-block is lower then the R block .. Also it takes away about 1.5 degree's of toe . So with the 3+2 wich is also lowerd is actually about 1.5 degree's of toe in a side....

We have played with milling the blocks lower and are still up in the air about where it should be ...

I use this mod only on carpet.....



Mike.