Associated RC12R5
#1606
Help...
As mentioned I converted my car and we run 13.5 1c lipo..i have an spx esc..and vortex 13.5...the track is around 70x30...i ran a 72 spur and 45 pinion..i need bottom end...what would anyone suggest...i ran profile 7...as far as pinion and spur...i have plenty top end..and the track is very technical.....
#1608
Maybe I just missed them, but did any of the setups from the IIC ever get posted?
#1611
Tech Fanatic
iTrader: (32)
this is my 12r5 with tamiya screws, ceramic bearings, Yokomo standoff and spring retainer. About to convert to 12r5.1 but motor mounts always on back order. Also is it me or am I seeing things? Is the 12r5.1 aluminum parts more lighter then the previous version or is it just the photo?
#1612
Where did you get the Yokomo Standoff?
#1615
Tech Addict
iTrader: (2)
this is my 12r5 with tamiya screws, ceramic bearings, Yokomo standoff and spring retainer. About to convert to 12r5.1 but motor mounts always on back order. Also is it me or am I seeing things? Is the 12r5.1 aluminum parts more lighter then the previous version or is it just the photo?
Best Regards Robert Krens
#1617
12R5.1
#1619
Tech Regular
Here Is my setup from the IIC.
Front end
.20 springs w/4 shims on the top and 30000 lube
1 1/2 * camber,full castor, 1/2* toeout
3.25mm ride height
Jaco magenta 41mm, 1/2 tire, jack
Rear
gold center and side springs
30wt in both shocks
3.25mm ride height
.75mm pod droop
Jaco magenta 43mm full tire, jack
Protoform AMR
Lrp Sxx 2,4,2,1
Reedy 1cell 4600 lipo
Lrp 4.5, 25/96
Hope this helps
Front end
.20 springs w/4 shims on the top and 30000 lube
1 1/2 * camber,full castor, 1/2* toeout
3.25mm ride height
Jaco magenta 41mm, 1/2 tire, jack
Rear
gold center and side springs
30wt in both shocks
3.25mm ride height
.75mm pod droop
Jaco magenta 43mm full tire, jack
Protoform AMR
Lrp Sxx 2,4,2,1
Reedy 1cell 4600 lipo
Lrp 4.5, 25/96
Hope this helps