gtb and 10.5 vortex
I got reman gtb from novak and 10.5 Team Orion Vortex. They worked fine for the first few minutes,then it stopped working. I have to push it and it will work as long as don't stop. This the first run on the gtb and the motor is used, I got off a guy in the for sale forum. Any ideas?
|
Anyone?
|
hmm...
the most obvious and possibly overlooked is the battery. It sounds like it might not have enough juice to get it going, so you have to turn it to start. What batteries are you using? |
Battery was a fully charged Maxamps 4k. Pack was on my light bulb discharger for 6-8min before it went dim. Not a battery problem. I had a gp 3300 on in it, then tried the fresh Maxamps.
|
it sounds like the speedo may not reconize the motor. Since you say it was used then maybe it might be the motor. If you have to push it to get it to start going the sensor may be the problem. Try hooking up a different brushless motor to it and see if that solves your problem.
|
from what I understood, you could only use Novak speedo with Novak motors:mad:
|
Originally Posted by BJ
(Post 3761764)
from what I understood, you could only use Novak speedo with Novak motors:mad:
|
You should be able to run the orion motor with the GTB ESC w/o any problem.
I would check your sensor harness on your motor and the actual plug in the motor itself... I have seen a few of the plugs have the pins fall out in the motors... |
Originally Posted by Steve Weiss
(Post 3762014)
You should be able to run the orion motor with the GTB ESC w/o any problem.
I would check your sensor harness on your motor and the actual plug in the motor itself... I have seen a few of the plugs have the pins fall out in the motors... Are Novak going to have adjustable timing in the software, like the LRP? |
Originally Posted by BJ
(Post 3761764)
from what I understood, you could only use Novak speedo with Novak motors:mad:
The Novak BL motors, however, are protected against thermal overload, only when used with a Novak BL controller. Perhaps reading about that specific feature caused the confusion. |
Originally Posted by NovakTwo
(Post 3762155)
All of the currently available sensored motors and escs are plug compatible.
|
My friend Ray uses the GTB and the Orion Vortex 10.5, and it seems he has no problems at all.:nod:
Mitch |
I got it used, so I am going to send it to Orion.
|
Is the reman gtb supposed to have blue program light? Mine has green, red, yellow. No blue.
|
Originally Posted by revo61
(Post 3763886)
Is the reman gtb supposed to have blue program light? Mine has green, red, yellow. No blue.
|
All times are GMT -7. It is currently 05:49 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.