Go Back  R/C Tech Forums > General Forums > Electric On-Road
tt01 drive shaft help >

tt01 drive shaft help

tt01 drive shaft help

Old 03-20-2007, 04:58 PM
  #1  
Tech Adept
Thread Starter
iTrader: (2)
 
Join Date: Feb 2007
Location: DC
Posts: 110
Trader Rating: 2 (100%+)
Default tt01 drive shaft help

I was just replacing the 3-piece center driveshaft with Tamiya blue hopup versions. To my surprise the end parts are just too short. As a result one can move the shaft all the way forward or rearward and the shaft can fall out. I've never know a tamiya part to not fit. Anyone else run into this?
catcars is offline  
Old 03-20-2007, 08:05 PM
  #2  
Tech Initiate
 
miller1990's Avatar
 
Join Date: Mar 2007
Location: Yorkville, IL
Posts: 29
Default

I used to have a TT01 and that was one of the first hop-ups I put on it but it fit just fine. You should first see if it is the right one for the TT01 (you never know) or maybe check to make sure the coupling or sleeve that the shaft goes into is positioned right in the chassis.

Hope this helps.

Good Luck!
miller1990 is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.