Xray T2'007
#2911
#2915
Tech Master
iTrader: (4)
How much is your Steering Dual Rate set at, I have mine at about 70%, is it possible that it is the Servo making noise? Also make sure the output shafts on the Multidiff are offset, you don't want them at the same angle, it will cause weel chatter. Other than that the only thing I can think of is something is rubbing, check the servo horn and make sure it isint rubbing the topdeck and that it isn't turning too far, like I said the Dual Rate needs to be turned down on the 007, I was told to go down to 60%, but I found 70% is better for me
#2922
Tech Elite
iTrader: (138)
That is helpful
Anyways, the servo link was waaaay too long, so I adjusted it to factory 49mm. I reset all my steering thru the M11 and adjusted the EPA's to 110%.
It's still grinding/chirping over 70% turning with throttle on. I cannot figure this out. I will try remove axles 1 by 1.
Anyways, the servo link was waaaay too long, so I adjusted it to factory 49mm. I reset all my steering thru the M11 and adjusted the EPA's to 110%.
It's still grinding/chirping over 70% turning with throttle on. I cannot figure this out. I will try remove axles 1 by 1.