Roche Rapide F1 EVO3
#196
With some parts not available anymore, maybe this is also Roche will introduce a new F1 car?
#198
Does anyone know if the rear axle height adjusters on the Evo 3 can be swapped with the units from another brand?
Not able to source the Roche ones here in Australia.
Thank you.
Not able to source the Roche ones here in Australia.
Thank you.
#200
OK, thank you...
Can you elaborate?
Can you elaborate?
#201
Well, seeing as I was utterly inundated with replies to my last post, I’m going to take a punt on Associated parts.
#202
Tech Master
iTrader: (5)
Another alternative is 3D print - I made some for an RJ Speed pan car printed in ASA / ABS.
Roche USA - any relief coming for the out of stock plastic parts? Or are we now running obsolete cars?
#203
R/C Tech Elite Member
iTrader: (28)
Older XRay X1s had a similar part - maybe 2017? I think I have one in the shop, will check today.
Another alternative is 3D print - I made some for an RJ Speed pan car printed in ASA / ABS.
Roche USA - any relief coming for the out of stock plastic parts? Or are we now running obsolete cars?
Another alternative is 3D print - I made some for an RJ Speed pan car printed in ASA / ABS.
Roche USA - any relief coming for the out of stock plastic parts? Or are we now running obsolete cars?
please see the carbon arms made by Krazedbuilds
#204
Tech Master
iTrader: (41)
The one person at our track who got the Krasedbuild lower arms couldn’t get the camber less than 2 to 2.5 degrees. His might have been flawed, not sure. The evo3 F1 is a great car but the 2 of us running the car at our track decided to move on from the car due to lack of parts support.
idbdoug
idbdoug
#205
The one person at our track who got the Krasedbuild lower arms couldn’t get the camber less than 2 to 2.5 degrees. His might have been flawed, not sure. The evo3 F1 is a great car but the 2 of us running the car at our track decided to move on from the car due to lack of parts support.
idbdoug
idbdoug
The machine calibration was off causing the Y-axis to be off.
They fixed the problem just havent had time to restock the correct ones.
#207
The one person at our track who got the Krasedbuild lower arms couldn’t get the camber less than 2 to 2.5 degrees. His might have been flawed, not sure. The evo3 F1 is a great car but the 2 of us running the car at our track decided to move on from the car due to lack of parts support.
idbdoug
idbdoug
#208
#209