does anyone know what the spring ratings are for the rear tweak? i got a package of 4 just wondering what the spring rates were

there's one listed several posts back in this thread
what set did you get?
specific for the 103?
Just put on the kit set up and get yer ass over to Cal on Sunday hahaha

Anyone run on black carpet yet? So far I really like how stable this car is on the carpet. Still playing with different setups and gearing, but mostly my driving.

I will be there

Lots of TRF103 parts are arrived at TQ RC RACING.

FYI, Thanks.

https://www.tqrcracing.com/shop/prod...p?s_maker_id=2

https://cimg6.ibsrv.net/gimg/www.rct...e45ff4c9c5.jpg
https://cimg8.ibsrv.net/gimg/www.rct...29c43f6f7a.jpg
https://cimg4.ibsrv.net/gimg/www.rct...20f21ed0de.jpg

Cuda, do you happen to have any spare O Rings for the front suspension? For some dumb reason mine are failing?

Find some small gauge steel wire (Lowes?) and twist tie them on instead of the o-rings. The o-rings are butyl rubber and fall apart and stretch out after a while.

Thx Mike, any spare IFS laying around i could bolt on?

Safety wire
 

Hey. Is there a chart/diagram that compares the kingpin springs and helper dprings for the 103 with AE varient? Thanks.

Agree....did you glue the edge of the plate? It really helps a lot....just make sure you apply enough CA to cover the edge. I had 1 serious crash at the rear and it still holds up.
This apply to the middle deck as well...it will start delaminate when installing the side sping screw if not applying enough CA, that hole is too close to the edge.

I like my TRF103, kit setup is fast and steady, not issue when completing with X1...the rest just driver's skill and luck:p

Also nothing need to upgrade...except 1 thing, the side links and probably the kit plastic pivot (part L5 i think). Strongly recommend to change them. They are too soft and got damaged easily.
I replaced them with #54460 and the car is perfect and hassle-free now.

Hi guys,

so as there was a discussion on the carpet setups I uploaded mine (with alu Chassis made by C. Donath) and Alex Stockers (carbon Chassis) setup of ETS Rd.1 on petitrc.
Sadly I damaged my alu Chassis pretty badly at the warm up laps of A1 as i traction rolled, so I think thats why i lost my pace on finals day.

Feel free to ask me anything, but Chance of a fast answeris higher on Facebook as I am not that often on rctech.

Best regards
Simon Lauter

Simon it very enjoyable to watch you race on youtube in ETS. Congrats on doing so well with the TRF103, Have you tried the t-bar setup with the car? Any little mods you do to make the car better for you? Tks and good luck racing;)