Team Associated SC5M Thread
|
|||
#616
What gearing is everyone running
#617
Tech Rookie
Spring Rate Comparisons
Does anyone know the comparable spring rates on the Kyosho springs vs. the new associated ones. The new AE springs are out of stock and I'm looking to run a little stiffer spring in the front on my SC5M. I've read a few people are running the Kyosho's but I haven't seen anything to get an idea on the rates.
#619
Does anyone know the part number for the axles to swap to clamping hexes in the front? Thank you
#621
#624
Tech Rookie
Manual is up on their site. http://www.teamassociated.com/pdf/cars_and_trucks/RC10SC5M/Team/manual_70006_RC10SC5M-TK.pdf
#625
Tech Champion
iTrader: (515)
If I have time I'm going to put my front springs on my spring dyno and compare to Kyosho springs. I think I need a step stiffer.....either that or much thicker oil. I had to use 1.6 2 hole pistons because they don't have 1.5s. I dunno. The truck is pretty badass other than that.
#626
Tech Regular
iTrader: (21)
So far the build has been good... all parts in the right bags, but I was missing one of the rear arm spacers. I'm getting ready to finish the build tonight with the shocks... anyone doing anything other than box stock? After reading this thread it seems the front end needs a stiffer solution...
#627
I am wanting to get one of these. I currently have 2 Losi 22sct 2.0. I dont want to have to buy all new wheels/tires. What could I do so I use the wheels I have now.
thanks
thanks
#628
Tech Prophet
iTrader: (84)
my understanding is. SCT wheels are zero offset and the AE wheels are +1mm offset. "If" that is the case, you could use a 1mm wider hex, shim the hexes out 1mm or use AVID CF Hex spacers. I would confirm those offsets, as I am not an SC offset expert. Just going off what I recall from my SCTE days
#630
Tech Apprentice
What length sensor cable is needed?