Serpent Spyder SRX2 SCT Thread
#241
I posted an issue with the bearings. My guess is my dusty track is not suited for the stock bearings. If you run on in a low dust track you should be fine. I am now using the Bocca green seals ($38 for all the rears) and have not had any more issues.
#242
Could someone post some pictures of the front sway bar mounted.
#243
Has anyone seen a setup for this truck on a loose 8th scale outdoor track? The base setup I found looks to be for a indoor high bite track.
Thanks
Thanks
#244
Has anyone upgraded to the steel idle gear? A second Serpent SCT at my local track just had their stock idle gear disintegrate after 4 race days on it.
#246
Tech Adept
iTrader: (8)
#247
So what tires are you using for dusty tracks? I'm currently using Panther raptors soft front/ super soft rear.
#249
Well got about 50 packs through this truck and no broken parts. Very happy with it so far. Front sway bar made a big difference. I would highly recommend it if you havnt tried one yet.
#250
is there a easy way to adjust diff without taking camber link off? Got mine together and just trying to break inn diff...
thanks in advance
thanks in advance
#253
#255
? ran mine last night stock 17.5 reedy mach 2 24 76 and came off at 160 degrees
short track medium grip same as my loss act and no problems with heat there?
turning tranny by hand was great except one spot bounded up just slightly..
another ?on tranny assembly it says diff screw on right but shows on left opposite of pinion..looking from back oc car would be on the left..wright
thanks
short track medium grip same as my loss act and no problems with heat there?
turning tranny by hand was great except one spot bounded up just slightly..
another ?on tranny assembly it says diff screw on right but shows on left opposite of pinion..looking from back oc car would be on the left..wright
thanks