Yes

I believe stock is 10/10/5? Try going to 15/20/7.

10/10/7 is stock, I planned on going up to what you recommended. Thought I'd ask to see if it could be something else first. Thanks

Hey guys

Feel like converting my truggy into a Monster Truck (ONLY AESTHETICALLY). So basically I need help with selecting a body. Can someone recommend MT bodies that actually fit well on this chassis? And also is there any mounting kit out there to hold MT bodies properly?

If you look at page1 of the mt410 page, it has a list of bodies.

I went from 10-10-7 to 10-12-7 to reduce ballooning, because my trigger finger doesn't listen.

it worked

hey guys i want to make my et48.3 all unis around like unis to hub and unis drive shifts
is this all i need or do i need anythink easl could you let me know as your help be greatful
part list
TKR5297 – Universal Driveshaft (center, rear, 170.5mm,
TKR5296 – Universal Driveshaft (center, front, 90.5mm
2X TKR5298 – Universal Driveshaft Set (front/rear, 140mm,

There are no UJ's for the centre driveshafts on the ET. The TKR5297 and TKR5296 are for the NT only.

Do they fit on the et

no

Anybody try 10, 15, 7 and how do you like it?

I did at first, it didn't feel right, dropped to 10-10-7, felt good, but too much ballooning, went to 10-12-7, and it was the sweet spot for me.

what did not feel good on 10,15,7 just wondering? did it help with balooning

It was a little edgy for teh track that I was on.

Any idea when the et48.4 is coming out? I may be looking to make the jump and don't want to get the 3 if the 4 is coming relatively soon.