+1

2wd sc for me first...time to dominate something in 2wd

Yea, see what some of the locals are running would be best, especially depending on dirt mixture. Is it pure clay or a mixture with some topsoil??

For topsoil mixture and even some clay tracks I've found that HB Beams, HB Megabites and AKA Wishbones are pretty good starting points and decent tires to have in the arsenal.

On the wheels, Losi scte rims seem to be the most widely used but I just picked up the DE Borrego 12mm rims and the inner webbing cleared fine and the 17mm version used on my Mugen sct has months on them and their still close to true... certainly no cracks or anything like that. They are more true than any other rims I've run for the given time period.

If your not against a dish wheel, that's what I'd recommend.

And to all... I conceded to defeat on the 17mm hex until my buddy finishes machining a set for me. Then the 17's go back on :tire: The plastic spacer for the Tekno hex's lasted me about a pack before they quit so their out for now.

Tires are more of a question you want to ask locals at your track, as far as rims I have used DE Trinidads, DE Borregos(don't like dish for sc but that's all they had), next set is avid sabertooths...none of these needed dremeling or anything and all in scte offset

I know ofna makes a set of hexes that fit a 6mm axle. They should work with the tekno axles for the eb48sl.

How did you like the AVID wheels?

I haven't personally ran the avids yet I have them sitting here and mounting up for this weekend but a few people said its there rim of choice now and they like em

I just picked up an SCT410 so I'm excited to be a member of the club. I have never raced before but it looks very tempting, but I'll probably just get acquainted with my Tekno a little before I jump in.

Quick question on motor choice. Reading up as much as I can on the Pro4 HD 4300, but can anyone with that combo chime in. I have a Pro4 4600 I just pulled out of an exo but tempted to switch it up.

Thanks!

YEa it just has a bit more power but no ROAR legal which it sounds like you don't care. I run the pro4600 now tho Cus I race. Honestly wouldn't spend a bunch of $ for such a small difference.

What gearing for the Hobbywing 4000kv motor.

Mine snapped clean during a qualifier. Was totally my fault, but it sucks that i dnf'd.
I'd recommend sticking with stock and replace when it gets a little bent.

Same experience here. The scte's carbons i never had an issue and i drove way worse then. I think the tekno's are mounted a little higher on the truck which causes them to snap easier.

Start around 17-18t.

I really like mine. All i run on this truck. A little flexy, but nothing that isn't comparable to other wheels on the market.

17-18 depending on track size.

What shock pistons are stock? 8x1.3?

10x1.2