Kyosho Ultima RB6 & RB6.6 Car Thread
|
|||
Tech Addict
iTrader: (10)
Tech Addict
iTrader: (10)
Super Moderator
iTrader: (81)
You don't see the shiny silver once it is installed in the car anyway.
Tech Addict
iTrader: (10)
Oh it doesn't bother me. Just pointing it out. A little filing on the old one and your good to go.
This new 6.6 is the kiddo's and I'm not allowed to crack the seal without him. Guess I'll just work on my old 6.0 hoopty.
This new 6.6 is the kiddo's and I'm not allowed to crack the seal without him. Guess I'll just work on my old 6.0 hoopty.
Tech Addict
iTrader: (10)
this is my first rb6.6 kit and I was wondering what is a good alternative for some steel bushings that are a direct fit.
Last edited by Smithracer11; 09-09-2016 at 06:01 PM.
Tech Champion
iTrader: (94)
Are they doing an rt6.6?
Super Moderator
iTrader: (81)
Metal on metal, most likely aluminum on aluminum will cause wear. You may want to look at the exotek parts. I don't have personal experience with them but maybe someone else does and can chime in.
My GF works at UpgradeRC, the company that manufactures the chassis skins for Schelle, and she is fitting the original skins on her 6.6. The way they made the chassis wider most likely will not work with a wider skin. It probably will not stick to the contours since it changes angles twice in such a small area. I think they are going to test it, but she thinks the skins will remain unchanged.
Tech Master
iTrader: (15)
How do you determine the antisquat degree to number/size spacer under the rear arm hangers/blocks?
For example 1mm spacer under the RR block and 0.5mm spacer under RF block equals what antisquat degree?
For example 1mm spacer under the RR block and 0.5mm spacer under RF block equals what antisquat degree?
Tech Fanatic
iTrader: (31)
I'm sure this has been asked but I couldn't find it anywhere.
Do I have to run a laydown in my RB6 to use the 6.6 body or will it work with my stand up 3-gear?
Do I have to run a laydown in my RB6 to use the 6.6 body or will it work with my stand up 3-gear?
Tech Master
iTrader: (1)
My GF works at UpgradeRC, the company that manufactures the chassis skins for Schelle, and she is fitting the original skins on her 6.6. The way they made the chassis wider most likely will not work with a wider skin. It probably will not stick to the contours since it changes angles twice in such a small area. I think they are going to test it, but she thinks the skins will remain unchanged.
Tech Master
iTrader: (1)
Anyone want to suggest a carbon fiber battery strap for the laydown config? The Mckune is a bit long. Pictures if you can Thanks!