Kyosho Ultima RB6 & RB6.6 Car Thread
|
|||
Thank you Eric
I wouldn't so eagerly throw out the stock pistons. I use them in my setup and the car runs great. Give them a try at least and change if necessary.
I have no plans on throwing them out . what is a good oil to start with on a small indoor mm with a sadde and med traction?
Tech Apprentice
I just recently installed both the aluminum steering crank set and aluminum steering plate on my rb6 and I feel like I have a lot more play (wiggle) now then when it was all plastic. Am I suppose to install washers with them or something to help with the play? If so metal or plastic and where? On the bottom or where the screw is? Or is play good? :-(
P.S. I've already installed the 1mm plastic collar on the bottom as the manual suggests. Just wondering if I should at anything else?
P.S. I've already installed the 1mm plastic collar on the bottom as the manual suggests. Just wondering if I should at anything else?
I just recently installed both the aluminum steering crank set and aluminum steering plate on my rb6 and I feel like I have a lot more play (wiggle) now then when it was all plastic. Am I suppose to install washers with them or something to help with the play? If so metal or plastic and where? On the bottom or where the screw is? Or is play good? :-(
P.S. I've already installed the 1mm plastic collar on the bottom as the manual suggests. Just wondering if I should at anything else?
P.S. I've already installed the 1mm plastic collar on the bottom as the manual suggests. Just wondering if I should at anything else?
http://www.amain.com/product_info.ph...King-Pin-Set-4
What are you guys useing to keep your battery in place when running MM with the battery pushed all the way back against the motor? If anybody have a clean Pic whould they please post it.
Tech Elite
iTrader: (40)
Anyone know if the JC Finnisher can be trimmed to fit the car in MM configuration? And look ok in the rear
It fits fine but you still have a gap at the back.
Tech Elite
iTrader: (1)
The guys running gear diffs what are you running for oil in it and does it just drop in the mm case?
Tech Apprentice
Also, blue thread lock the screws as they'll come loose after runs.
Cheers,