http://www.rctech.net/forum/10588401-post96.html:lol:

Nice pair of Hooters.... on Hellcat Short Course bodies. :lol:

http://sphotos.xx.fbcdn.net/hphotos-...38324345_n.jpg

Is this were I should reinforce my Hellcat?
https://lh5.googleusercontent.com/-U...38324345_n.jpg

Yes and if you have the front vents cut out like I do add some to the outer part of the fender area. With the bodies wrapped like mine the only place I add some tape and shoe goo is the rear.

How did you cut the front vents out?

Dremel the slot with a cut off wheel then I take a 1/8 drill bite and use that to round the ends off. I use an xacto knife to do the very front one to get the point like the body has on the first vent. Its a three tool process for me but take your time and they will turn out nice.

Chris Hwaleks Method Hellcat body making us all look bad with paint. :cool:

http://sphotos.xx.fbcdn.net/hphotos-...56841580_n.jpg

I do mine a little different from Cameron.

I drill a 1/8" hole at either end of the vent, then use the cutoff tool to connect the holes. If you want the slot wider, stack up more than one cut off wheel on the arbor.

Si, mucho! :nod:

For the SC10 4x4 mounting , lowest in the rear and 2nd highest in the front correct?

3 in the front, 1 in the rear. Leave the front apron extra long.

My new Hellcat body, Painted by Trackside Paintz!!
http://i1158.photobucket.com/albums/...sidepaintz.jpg

If you can't tell painting is not my strong suit lol:

https://lh4.googleusercontent.com/-F...4/DSC_0037.JPG

https://lh5.googleusercontent.com/-o...4/DSC_0038.JPG

https://lh6.googleusercontent.com/-d...4/DSC_0039.JPG

https://lh4.googleusercontent.com/-3...4/DSC_0040.JPG

ME EITHER!! That's why I had someone else do it. :nod: He did forget one sponsor on it so I have to sticker it with the missing sponsor.:blush:

Hey look at the bright side, you have a sponsor :cry:
:lol: