AE Vented V2 Slipper Hubs

Reply Subscribe

Thread Tools

Search this Thread

04-30-2011, 12:55 PM

#16

Jmuck69

Tech Champion

iTrader: (14)

Join Date: Jan 2010

Location: Atlanta, GA.

Posts: 5,061

Trader Rating: 14 (100%+)

Quote:

Originally Posted by Wild Cherry

racer

Sad, I have tighten down the Trans case way too tight before , big rub marks on my back slipper plate ......

I rubbed a nice deep groove into my plates. I just busted out the dremel and cut off the extra length and not have that happen again.

By the way, I bought the B4 arms last night since I have been running the B44 arms. The B4 arms are stiffer. It should be B4 then B44 then the carbon arms in terms of stiffness. So you were right.

04-30-2011, 03:27 PM

#17

mtnbiker67

Tech Adept

Thread Starter

Join Date: Jan 2011

Location: Nor Cal

Posts: 124

Trader Rating: 0

I did not touch nor are the tranny screws rubbing.

I simply took one plate off and replaced it with another.

I thought about the shim thing. However, I am a bike mechanic and I have a theory on shims. Lets just say I don't use them unless spec'd by manufacturer.

I'm going to wait and see how AE replies to my email.

Last edited by mtnbiker67; 04-30-2011 at 04:22 PM.