Jammin CRT.5 Brushless
#556
Tech Master
iTrader: (50)
Got my Jammin back together. I've owned it about 2 years and ran it twice before today. It came with a sidewinder and a 4600kv motor. I immediately put buggy wheels on it and had a blast but the esc couldn't take it and would over heat. Its sat on the shelf since then.
Now its back to life with a 2650kv motor and MMM esc. Both have been sitting on top of the car for the whole two years, just never got around to swapping it.
For the pinion I tried a 19t and it just wasn't fast enough. I had a 30t, but it wouldn't fit. Looks like 25t is the largest that will fit in a RCM motor mount with the stock center gear.
Its fun like this on 2S, but my plans are to run it on 3S. With the current setup the motor was 116F, esc 100F, and battery 95F.
Now its back to life with a 2650kv motor and MMM esc. Both have been sitting on top of the car for the whole two years, just never got around to swapping it.
For the pinion I tried a 19t and it just wasn't fast enough. I had a 30t, but it wouldn't fit. Looks like 25t is the largest that will fit in a RCM motor mount with the stock center gear.
Its fun like this on 2S, but my plans are to run it on 3S. With the current setup the motor was 116F, esc 100F, and battery 95F.
#557
Tech Adept
Traded off my sc10 4x4 for one of these NIB. What a blast. 3000kv Tacon 3660, LT4, and 2s lipo. Surprisingly stable for such a short wheelbase.
I picked up another from fleabay this weekend for my winter project. Its going to get a severely stretched wheelbase, sc wheels and tires, and a tube cage (think Exo Terra). Can't wait for the cold weather to roll around.
I picked up another from fleabay this weekend for my winter project. Its going to get a severely stretched wheelbase, sc wheels and tires, and a tube cage (think Exo Terra). Can't wait for the cold weather to roll around.
#558
Anyone know what a good diff setup is for the sidewinder sct combo?
#560
Tech Adept
#561
Tech Adept
Also...I started my winter project early.
Still lots to do, but complete enough to drive.
Swing out battery tray...
Still lots to do, but complete enough to drive.
Swing out battery tray...
#562
Tech Master
iTrader: (204)
very nice looking truck, someone was looking for diff set ups, thinking 3,3,2 works, but our current set ups require locked center and rear diff, hobbywing 150 amp speedo with tekin 2050kv motor with a 30 tooth mod 1 pinion gear, powered by 6s, run time kinda sucks tho and keeping the little hexes in the hubs are the hardest part, but its a rush to drive tho, especially at 60 mph and it breaks the rear tires loose
I love them little trucks
I love them little trucks
#565
i picked up a crt.5, it has been changed to captured ends on the steering links, but they are hitting the front dif and i have NO steering at all, is there a certain rod end i should be using to get them to clear the diff case wile turning?
#566
Tech Initiate
u wana sell it or trade
#567