HPI SC-15 ESC Instructions and problems with reverse
01-29-2010, 07:28 AM
#1
HPI SC-15 ESC Instructions and problems with reverse
Does anyone have any instructions for the HPI SC-15 ESC? For the life of me, I cannot find it on any website or forum! I just purchased one and need to set it up for my Rustler.
It seems like forward is working fine, but I cannot get it to go into reverse at all. It does seem to recognize the forward and reverse signals because the LED changes for both, but it will not go into reverse. I assume it either needs to be calibrated to the receiver or it is in Forward&Brake mode. Without the instructions, I'm pretty lost!
Any help would be greatly appreciated! Thanks!
It seems like forward is working fine, but I cannot get it to go into reverse at all. It does seem to recognize the forward and reverse signals because the LED changes for both, but it will not go into reverse. I assume it either needs to be calibrated to the receiver or it is in Forward&Brake mode. Without the instructions, I'm pretty lost!
Any help would be greatly appreciated! Thanks!
01-31-2010, 12:06 PM
#2
Bump - anyone?
01-31-2010, 12:23 PM
#3
01-31-2010, 06:52 PM
#4
Thanks, but maybe I'm still missing it somewhere. I've been all through that manual and can't find anything about calibrating, activating, programming, disabling or enabling reverse. Arrrrgh!
11-19-2013, 03:58 PM
#5
Tech Rookie
I know it's an old thread, but...
Was there ever a solution found?
I'm seeing a lot of RC sites that tell people to read the manual, (program mode...) and they even give the page number, but, that seems to only apply to the Water Proof newer model.
Was there ever a solution found?
I'm seeing a lot of RC sites that tell people to read the manual, (program mode...) and they even give the page number, but, that seems to only apply to the Water Proof newer model.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
